Wireless Settings - Panasonic PT-F200 Network Manual

Network setting of the projector

Wireless settings

Select [NEXT] on the IP address setting window to switch to the wireless setting window.
Make the settings related to the wireless connection between the projector and the network.
WIRELESS DETAILED SETUP
USER1
SSID
MODE
AUTHENTICATION
ENCRYPTION
RETURN
CHANNEL
SELECT
ENTER
RETURN
SSID ※ : If the mode is [INFRASTRUCTURE
MODE : Select [AD HOC] or [INFRASTRUCTURE].
AD HOC
※ : Connect projector and computer directly without access point.
INFRASTRUCTURE ※ : Connect through access point.
AUTHENTICATION : Set the user authentication method used by the network to be connected.
OPEN : Select when making a connection using [AD HOC], or when the access point authentication method is
OpenSystem
SHARED : Select when making a connection using [AD HOC], or when the access point authentication method is
Shared Key
WPA-PSK ※ : Select when the access point authentication method is WPA-PSK.
ENCRYPTION : Select the encryption method to be used for communication between the projector and the network.
NONE : Select when transmit without encryption. It is selectable only when [AUTHENTICATION] is [OPEN] or
[SHARED].
WEP ※ : Select when ENCRYPTION is WEP.
TKIP ※ : Select when ENCRYPTION is TKIP.
Selectable when [AUTHENTICATION] is [WPA-PSK].
AES ※ : Select when ENCRYPTION is AES.
Selectable when [AUTHENTICATION] is [WPA-PSK].
※ "Glossary" (See page 71)
• If you are unable to connect to the wireless LAN through the access point even after performing the steps in "
settings (See page 22)," contact the manufacturer of the access point.
• This projector does not conform to WPA2, IEEE 802.1x.
2/3
Panasonic Projector
AD HOC
OPEN
NONE
1
NEXT CANCEL
[AD HOC], enter the same character string as that of SSID set on the computer to be connected.
※ .
※ .
(cont.)
※ ], enter the SSID registered at the access point. If the mode is
55
Projector