Option Settings; Screen Display; Auto Keystn; Auto Ype Pr Ei - Panasonic PT-L711U Operating Instructions Manual

Option settings
Use the A and V buttons on the
projector or remote control unit to
select an item, then press the < or
> buttons to change the setting.
SCREEN DISPLAY
ON The signal name is
displayed in the top-right
corner of the screen when
the input signal is
changed.
Use this setting when you
do not want the signal
name to be displayed.
AUTO KEYSTN
This should normally be set to ON.
ON During automatic setup,
the angle of tilt of the
projector is detected and
keystone distortion ís
corrected automatically.
Use this setting when you
do not want automatic
keystone correction to be
carried out during
automatic setup, such as
when the screen itself is at
an angle.
OFF
OFF
36
AUTO Y-PB-PR
AUTO Y-PB-PR
RGB or YPePR is RGB
selected format
HDTV = jautomatical
(1080i) Beanie setting
synchronising 9ecomes
signal status. | Valid
RGB or YPBPR is
selected automatically
depending on the
synchronising signal
Status.
AUTO RGB IN
This should normally be set to ON.
ON During automatic setup,
the projector selects
whichever one of the
RGB1 IN or RGB2 IN
connectors has a signal
being input, and uses that
signal for projection.
(If a picture is being
projected, the signal
source is not automatically
changed.)
Use this setting when you
do not want the signal
source to be changed
automatically during
automatic setup.
RGB FORMAT
V AÀ
This setting is only valid when an
HDTV (10801) signal is being input
and "AUTO Y.PB-PR" is set to OFF.