Connecting Through The Access Point - Panasonic PT-F200 Network Manual

Connecting with wireless LAN

Connecting through the access point

You can make the setting for infrastructure mode
administrator on network settings before changing any settings.
※"Glossary" (See pages 70 - 71)
Projector settings
1
Turn on the projector and press the [NETWORK] button on the remote control.
Select [USER 1] - [USER 3] from [WIRELESS LAN] at the network menu and press
2
the [ENTER] button.
Set the details of network and select [OK].
3
As for network setting items, see pages 54 - 56.
Confirm to your system administrator on network settings before changing any settings.
The projector's MAC address
("Verifying settings"
Computer settings
4
Turn on the computer.
5
Make the network setting according to your system administrator.
6
Connect to your access point.
Start Wireless Manager ME 4.5, click [Wireless LAN] on the <Network Adapter
7
Selection> window and select the network adapter connected to the access port.
A confirmation message appears asking whether to switch the projector to the network or not. Select [No].
Select the desired projector in the [Detailed] screen of the <Select Access Port>
8
window and click [OK].
The launcher appears and the connection with the projector is established.
("Description of the launcher"
If the projector is not displayed, click [Designate] followed by [ADD], then enter the IP address set in the projector using
the <Access Port Registration> window, and click [REGISTER]. (See page 30)
If you are unable to connect to the wireless LAN through the access point even after performing the steps in "
settings," contact the manufacturer of the access point.
(connection through the access point
※
can be checked with [STATUS] in the network menu of the projector unit.
※
see page 59) ※"Glossary" (See page 70)
See page 33)
(cont.)
22
); however, confirm to your system
※
Projector