How To Use Advanced Menu; Digital Cinema Reality; Format (To Input Betacam With Ycbcr 480I) - Panasonic PT-D7700 Operating Instructions Manual

How to use ADVANCED MENU

DIGITAL CINEMA REALITY

Increase the vertical resolution when the PAL (or SECAM) 576i signal input or the NTSC 480i signal input is applied.
Procedure of adjustment
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
ADVANCED MENU
DIGITAL CINEMA REALITY AUTO
FORMAT
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
SYNC.TERM
RASTER POSITION
Note
• In DIGITAL CINEMA REALITY mode, the image quality will be deteriorated if 30p FIXED or 25p FIXED
is selected when the signal is not a 2:2 pulldown signal.

FORMAT (To input BETACAM with YCbCr 480i)

When receiving a picture of 480i with analog component signal YCbCr input, the input level of Cb and Cr can be switched.
Procedure of adjustment
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
TEST PATTERN
ADVANCED MENU
DIGITAL CINEMA REALITY AUTO
FORMAT
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
SYNC.TERM
RASTER POSITION
:MENU SELECT
:CHANGE
Note
• This function is available only when input signals are supplied through the analog RGB input module
(ET-MD95RGB). RGB1, RGB2 inputs do not support BETACAM signals.
• This function can be switched only when receiving the picture of 480i in the YCbCr mode.
It cannot be switched when receiving the picture of signals other than RGB-REALITY mode, RGB
mode and 480i.
• SMPTE is the factory default.
SMPTE
OFF
75
SMPTE
OFF
75
Press the "MENU" button.
The MAIN MENU screen will be displayed.
Select "ADVANCED MENU" with the
buttons.
Press "ENTER" button.
The ADVANCED MENU screen will be displayed.
Select "DIGITAL CINEMA REALITY"
with the buttons.
OFF: Unforced cinema processing
AUTO: Performs automatic detection and cinema
processing. (factory default)
30p FIXED: Forced cinema processing (2:2
pulldown) is performed when a 480i
signal is input.
25p FIXED: Forced cinema processing (2:2
pulldown) is performed when a 576i
signal is input.
Press the "MENU" button.
The MAIN MENU screen will be displayed.
Select "ADVANCED MENU" with the
buttons.
Press "ENTER" button.
The ADVANCED MENU screen will be displayed.
Select "FORMAT" with the
buttons.
Switch the signal format with the
buttons.
• This toggles between SMPTE and BETACAM.
<Signal level>
Format Y
SMPTE 700 mV
BETACAM 714 mV
Synchronous part C , C
b r
300 mV ±350 mV
286 mV ±504 mV
61