Advertisement
Description of this Upgrade
Step 10. Install *NEW* and Reused Direct Digital Synthesis (DDS) Assembly Cables
Step 10. Install *NEW* and Reused Direct Digital Synthesis (DDS)
Assembly Cables
1. Connect new LFE cables in the order shown in
Figure 8
Install New LFE Assembly Top Cables (N5240-60112, N5240-60113, and
N5240-60114)
2. Connect the following new cables in the order listed. Torque screws to
28
bottom-side end of the cable was installed in
Cables" on page
19.
9 in-lbs.
Refer to
Figure 9 on page
—
—W51(N5224/5B & N5244/5B)/W61 (N5227B & N5247B)
(N5240-20125) A15 13.5 GHz (LO) synthesizer assembly J5 to A21
HMA26.5 RF IN (One end was connected in
Bottom Cables" on page
—
—W1 (N5240-20124) A15 13.5 GHz (SRC 1) DD synthesizer
assembly J4 to A5 26.5 GHz source (1) board Source 1 RF IN
—
—W2 (N5240-20126) A15 13.5 GHz (SRC 2) direct digital
synthesizer (J6)-SRC 2 RF IN
Figure 8 on page
"C. Install Some *New* LFE
29.
24)
Installation Note N5225-90143
28. The
"Step 7. Reinstall
Advertisement
