Advertisement
Description of this Upgrade
Step 12. Add Back Plate and Cable to Rear Panel (Option 422/423 With and Without
029 Only)
Step 12. Add Back Plate and Cable to Rear Panel (Option 422/423
With and Without 029 Only)
For this step refer to
also,
1. Remove the plastic cap that covers the rear panel hole where the back
2. Connect back plate (N5240-00015) to the PNA's rear panel (item (1) in
3. Connect the one end of the N5240-20127 cable to the inside of the back
4. Connect the other end of the cable (N5240-20127) to A11 DD synthesizer
Figure 13
Install Back Plate to Rear Panel (N5240-00015, (x2) 0515-0374)
Installation Note N5225-90143
Figure 13 on page 35
Figure 9 on page
29.
plate and N5240-20127 cable installs.
Figure
13), using (x2) 0515-0374 screws. Torque to 9 in-lbs.
plate (item (2) in
Figure 13
21 in-lbs.
J7 (item (1) in
Figure 14 on page
and to
'Figure 14 on page
and item (2) in
Figure 14 on page
36).
(1) Install small plate
N5240-00015 using x2
0515-0374 screws.
Torque to 9 in-lbs.
(2) Connect N5240-20127 cable to
back plate. See also,
.
page 36
Torque hex-nuts to 21 in-lbs.
36. See
36). Torque to
Figure 14 on
35
Advertisement
