Advertisement
Description of this Upgrade
Step 13. Install "SRC3 J13" Label on Rear Panel (Option 422/423 With and Without
Option 029 Only)
Step 13. Install "SRC3 J13" Label on Rear Panel (Option 422/423
With and Without Option 029 Only)
For this step, refer to
1. Verify that rear panel surface is clean.
2. Install SRC3 J13 label to the rear panel.
3. Add SMA load (1250-4261). Torque to 8 in/lbs.
Figure 15
Install "SRC3 J13" Label on Rear Panel (N5240-80042)
Step 14. Remove and Replace the A55 Solid State Drive (SSD)
Skip this step, if your PNA already has:
– CPU greater than Version 7
– CPU Version 7 that already had a 256 GB SSD (N5242-60135) installed
with Disk Drive Version S.41.04.05 and Application Code Version A.14.00
firmware or greater
For instructions, click the Chapter 7 bookmark "Removing and Replacing the
A55 Solid State Drive (SSD)" in the PDF Service Guide
Installation Note N5225-90143
Figure
1. See
"Downloading the Online PNA Service Guide" on page
15.
1
.
7.
37
Advertisement
