Removing The Chassis Cover - Supermicro SC826 JBOD User Manual

4-4

Removing the Chassis Cover

2
Removing the Chassis Cover
1. Power down the server as descrbed in section 4-2, lay the chassis on a flat
stable surface and remove the chassis cover.
2. Remove the two screws from the sides of the chassis cover.
3. Press the release tabs to remove the cover from the locked position. Press both
tabs at the same time.
4. Once the top cover is released from the locked position, slide the cover toward
the rear of the chassis.
5. Lift the cover off the chassis.
Caution: Except for short periods of time, do not operate the system without the
cover in place. The chassis cover must be in place to allow proper airflow and
prevent overheating.
1
3
Figure 4-3. Removing the Chassis Cover
Chapter 4: Chassis Setup and Maintenance
5
1
3
4
4-7
1
2