Answering System Settings - Panasonic KX-TH102M Operating Instructions Manual

i
Answering System
Key Remote command
{#}{2}{7}
Record a greeting
message for line 2 only.
{#}{0}{7}
Record a common
greeting message for both
line 1 and line 2.
{#}{1}{8}
Turn answering system on
for line 1 only.
{#}{2}{8}
Turn answering system on
for line 2 only.
{#}{0}{8}
Turn answering system on
for both line 1 and line 2.
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume operation, enter a remote
command within 15 seconds, or the
voice guidance will start.
Note:
L After selecting the line(s), memo
messages do not play.
Turning on the answering system
remotely
If the answering system is off, you can turn
it on remotely by calling the line selected in
"Turning the answering system on o" on
page 79.
1
Dial your phone number.
2
Let the phone ring 15 times.
L The unit answers your call with the
greeting message.
L You can hang up, or if you call from a
touch tone phone, you can enter your
remote code and begin remote
operation (page 83).
Skipping the greeting message to leave
a message
You can leave a message just as any
outside caller can. Call your phone
number, then press {*} to skip the
greeting message and record your
message after the beep.
84
For assistance, please visit http://www.panasonic.com/phonehelp
Answering system
settings
Remote code o
A remote code must be entered when
operating the answering system remotely.
This code prevents unauthorized parties
from listening to your messages remotely.
1
{MENU} i A i {SET}
2
"Remote code" i {SET}
3
Enter the desired 2-digit remote code.
(Default: "11")
4
{SET} i {STOP}
Ring count o
You can change the number of times the
phone rings before the unit answers calls.
"Toll saver": The unit answers on the
2nd ring when new messages have been
recorded, and on the 4th ring when there
are no new messages. If you call your
phone from outside to listen to new
messages (page 83), you will know that
there are no new messages when the
phone rings for the 3rd time. You can then
hang up without being charged for the call.
1
{MENU} i A i {SET}
2
"Ring count" i {SET}
3
Select the desired line.
4
Select the desired setting. (Default: "4
rings") i {SET} i {STOP}