Table of Contents
Advertisement
Useful Information
Problem
The camera sensor does
not respond.
The camera sensor
responds but a person is
not shown.
The pictures are not
stored in the cordless
camera.
I pressed {Call button}
but the cordless camera
does not page the
handset or my computer.
"Camera detect" is
displayed on the handset
or a pop-up message
("Notification") is
displayed on your
computer.
110
For assistance, please visit http://www.panasonic.com/phonehelp
Cause & solution
L The camera sensor does not respond unless the
detection mode is set to "Motion & Audio", "Motion
only", or "Audio only" beforehand. Change the
detection mode (page 62).
L While a handset or a computer user is monitoring the
cordless camera, the cordless camera stops detecting
motion and/or sound.
L The cordless camera cannot take a picture when a
person passes in front of the cordless camera too fast.
L If a handset or a computer user starts monitoring the
cordless camera while it is taking pictures after
detection, the cordless camera stops taking pictures.
L You selected "No Overwrite" for the method of saving
the cordless camera images and the cordless camera's
memory became full. Erase unnecessary images (page
56, 59) or change the setting to "Overwrite image"
(page 63).
L The call button does not work unless the detection
mode is set to "Call button". Change the detection
mode to "Call button" (page 62).
L While a handset or a computer user is monitoring the
cordless camera, you cannot page them by pressing
{Call button}. Wait until the handset or the computer
user end monitoring.
L When the cordless camera detected motion and/or
sound or the call button of the cordless camera was
pressed, you were not near the handset or your
computer and could not answer the page. After you
monitor the cordless camera which paged you, the
indication disappears.
Advertisement
Table of Contents
