FlySky FMS-R3A Manual

接收机概览 Overview
产品规格 Product specification
Product Model: FMS-R3A
Compatible Transmitters: FMS-G3
1:18 , 1:24 simulation cars or rock cars
Model Type:
PWM Channels: 3
Number of car light interfaces：1
RF: 2.4GHz ISM
2.4G Protocol: AFHDS 2A-BS
Maximum Power: 20dBm (e.i.r.p.) （EU）
Resolution: 1024
Antenna: Single External Antenna
Input Power: 2S Lipo batteries
Continuous/Peak Current: 10A/40A
Data Output: PWM
BEC Output: 5V/1A
Distance: >100m (Ground distance without interference)
Temperature Range: -10℃ ~ +60℃
Humidity Limit: 20% ~ 95%
WaterProof: PPX4
Online Update: No
Dimensions: 32mm*24.4mm*12mm
Weight: 8g
Certifications: CE，FCC ID: 2A2UNR3A00
对码 Binding
The receiver automatically enters the binding state once it is powered on.
Follow the steps below to bind with the receiver:
1. Put the transmitter into binding state, refer to the manual of the transmitter.
2. Put the receiver into binding mode by powering on the receiver, the receiver LED flash qucikly.
3. The binding process is finished when the transmitter LED stops flashing and is solid on.
4. Check to make sure the transmitter and receiver are working correctly, if there are any issues or unexpected operation arise,
follow the steps above to bind again.
Notes:
1. If the transmitter disconnects with the receiver, the transmitter LED will go into three-flash-one-off state.
2. Set the transmitter to its binding state first, and then set the receiver to its binding state. If the binding is not finished
within 10s, the LED of the receiver will enter its slow flashing state.
http://www.flysky-cn.com
Copyright ©2022 Flysky Technology co., ltd
FMS-R3A
接收机 Receiver
[1] Motor interface
[2] Battery line
[3] Power Switch
[4] Antenna
[5] LED
[6] CH3
[7] CH1
[8] Car light interface