Audio Dubbing; Speaker - JVC GR-DVP7EA Instructions Manual

70
EN

Audio Dubbing

The audio track can be customised only when
recorded in the 12-bit and SP modes. (
Stereo microphone
Headphone
connector
Remote sensor
USING THE REMOTE CONTROL UNIT (cont.)
pg. 43)

Speaker

A.DUB
PLAY
PAUSE
STOP
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB
(D) on the remote
control, press PAUSE
(9). The "9D"
indicator appears.
3
Press PLAY (U), then
begin "narrating".
Speak into the
microphone.
● To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9), then
STOP (8).
To hear the sound during Audio Dubbing...
Connect optional headphones to the headphone
connector or use the S/AV connector, and set the
"12BIT MODE" to the desired mode;
• "SOUND 1" for the playback sound.
• "SOUND 2" for the dubbed sound.
• "MIX" for the Playback and dubbed sound.
To hear the dubbed sound during playback...
Set "12BIT MODE" to "SOUND 2" or "MIX".
( pg. 38, 50)
NOTES:
● When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
● If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
● During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
● To perform Audio Dubbing while watching on the
television, make connections. (
● To perform Audio Dubbing with a video unit
connected to the camcorder's S/AV connector, first
set "S/AV INPUT" to "A/V IN" in VIDEO Menu.
( pg. 51)
9D
MIC
pg. 24, 25)