Self-Timer - JVC GR-DVP7EA Instructions Manual

Self-Timer

VIDEO/MEMORY
Recording Start/
Power Switch
Lock Button
MENU Button
SET/SELECT Button
When the Recording Start/Stop Button or SNAPSHOT
is pressed, the tally lamp changes as shown:
Switch
Stop Button
+, – Button
Begins blinking Blinks quickly
(Self-Timer starts) (Self-Timer shooting
starts soon)
Once the camcorder is set, the camcorder operator
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
1
Set the Power Switch to "M" while pressing down
the Lock Button located on the switch.
2
Open the LCD monitor fully, or pull out the
viewfinder fully.
● You can tilt the LCD monitor upward to 180°
so that it faces forward and view yourself while
self-recording with the viewfinder pushed
back.
3
Set "SELF TIMER" to
"ON ". ( pg. 38)
4
To engage the Self-
Timer for video
recording, press the
Recording Start/Stop
Button.
● After 15 seconds, the
beep sounds and
video recording
starts.
5
To stop Self-Timer
recording, press the
Recording Start/Stop
Button again.
● The camcorder re-
enters Record-
Standby mode.
OR
5
Press SNAPSHOT.
● After 15 seconds, the beep sounds and
snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
6
To end Self-Timer recording, select "OFF" in
step 3.
NOTE:
If "BEEP" and "TALLY"are set to "OFF" (
the beep does not sound and the tally lamp does not
light.
Turns off
(Self-Timer snapshot recording starts)
Stops blinking and stays on
(Self-Timer video recording starts)
After approx. 15 sec.
53
EN
SEL F – T I MER – OF F
ON
Self-Timer indication
pg. 47),