Table of Contents
Advertisement
Handling Error Messages
If transmitter errors are displayed on the camera LCD monitor, refer to the examples of
corrective actions in this section to eliminate the cause of the error. When an error has
occurred, the <LAN> lamp on the transmitter blinks and the error number is shown on the LCD
panel. The error details can also be checked in the menu, [WFT settings]
description].
Click the error number in the following chart to jump to the corresponding page.
11 (p.99)
21 (p.99)
26 (p.102)
41 (p.103)
46 (p.105)
51 (p.106)
61 (p.107)
66 (p.109)
71 (p.110)
81 (p.110)
91 (p.110)
When the error below is displayed
* This error is not displayed on the camera LCD monitor.
* This error is also displayed when the transmitter is connected to a camera not compatible with
the WFT-E7 (Ver.2).
If [Waiting to retry transfer...] is displayed
Note that if you cancel image transfer or turn off the camera, auto retry is not performed. Follow
the steps on page 40 to transfer the images.
98
12 (p.99)
22 (p.100)
23 (p.100)
42 (p.104)
43 (p.104)
47 (p.106)
52 (p.106)
53 (p.106)
62 (p.107)
63 (p.108)
67 (p.109)
68 (p.109)
72 (p.110)
73 (p.110)
When "ERROR 01" is displayed on the transmitter LCD
panel, firmly reconnect the camera and the transmitter with
the interface cable.
If image transfer via FTP fails after shooting, the
screen on the left is displayed. Also, an error number
is displayed on the transmitter's LCD panel, and the
<LAN> lamp blinks in red. Check the error number and
eliminate the cause of the error.
Once the cause of the error is eliminated, the images
whose transfer previously failed will be transferred
automatically.
24 (p.101)
25 (p.102)
44 (p.104)
45 (p.105)
54 (p.106)
64 (p.108)
65 (p.108)
69 (p.109)
[Error
Advertisement
Table of Contents
