Re-Registering The Handset; Registration - Panasonic KX-TG5471S Operating Instructions Manual

Re-registering the Handset

If "No link to base. Move closer to base and try again." is
displayed even when using the handset near the base unit, the handset may have
lost communication with the base unit. You need to re-register the handset to that
base unit.
Make sure the base unit is not being used. Have both the handset and base
unit nearby during registration.
1
Handset: Press [MENU].
2
Handset:
Scroll to
Initial setting
"
[d] or [B]
, t
3
Handset:
Scroll to "Registration" by pressing [d]
or [B] then press the soft key (
,
4
Base unit:
Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
5
Handset:
(1) Press the soft key (
(2) Wait until a long beep sounds and the
display shows the following.
• Registration is complete.
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR/INTERCOM/TRANSFER] on the base unit.
Important:
Do not register other handsets to this base unit. Only the included handset can
operate properly with the KX-TG5471 base unit.
For assistance, please call: 1-800-211-PANA(7262)
hen press the soft key
).
O K
Handset & Base Unit
by pressing
"
( ).
SELECT
).
SELECT
Special Features
Initial setting

Registration

Press LOCATOR
on base unit
for 3 sec.
Then press OK
BOX 1 BOX 2
SPIPRIVACY1
IN USE
Handset [1]
Registered
O K
[2]
55