Line Mode; Base Unit Settings - Panasonic KX-TG5456S Operating Instructions Manual

Programmable Settings
may not work correctly. Consult your
PBX supplier for the correct setting.

Line mode

The line mode is preset to "B" and
generally should not be adjusted. If
S on the handset is not displayed
properly when another phone connected
to the same line is in use, the line mode
selection is incorrect. Set line mode to "A".
1
Press {MENU} (middle soft key).
2
Scroll to N, then press {SELECT}.
3
Scroll to "Set tel line", then press
{SELECT}.
4
Scroll to "Set line mode", then press
{SELECT}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {SAVE}, then press {OFF}.
42
For assistance, please visit http://www.panasonic.com/consumersupport

Base unit settings

Base unit ringer volume
4 levels (high/medium/low/off) are
available.
Important:
L Make sure the base unit is not being
used.
Press {<} or {>} repeatedly to select the
desired volume.
L To stop ringing, press {STOP}.
To turn the ringer off, press and hold {<}
until the unit beeps 2 times.
O
will be displayed.
L
Base unit ringer tone
This feature must be set by using the
handset.
1
Press {MENU} (middle soft key).
2
Scroll to N, then press {SELECT}.
3
Scroll to "Set base unit", then press
{SELECT}.
4
Scroll to "Ringer tone", then press
{SELECT}.
5
Press {V} or {^} repeatedly to select
the desired setting.
L If the ringer volume has been turned
off, the base unit will not ring.
6
Press {SAVE}, then press {OFF}.
Base unit interrupt tone
This tone lets you know when you receive
a call while you are on an intercom call.
"2": The tone will sound 2 times.
"On": The tone will sound for as long as the
line rings.
"Off": Turns this feature off.
This feature must be set by using the
handset.