Installation; Pre-Installation - Comfort Bilt HP50S Owner's Manual

Hide thumbs Also See for HP50S:
Table of Contents

Advertisement

Installation

Pre-Installation

Unpacking:
Remove cardboard lid, outer box sleeve, and packing foam.
Inspect for any shipping damage. (Preferably before delivery
team leaves)
Unscrew the mounting L brackets that secure the rear of the
stove to the pallet. (4mm Allen)
Open hopper lid and remove control panel, power cord, remote
control, and all literature and packing material from the hopper.
Open the front door via the latch on the right side (see picture)
and remove cardboard packing material from the firebox
chamber.
Remove any tape or adhesive on the outside of the glass.
Mounting the Control Panel:
1.
Remove all four Phillips mounting screws along the top rear of
the stove where you wish to mount the controller bracket.
2.
Line up the holes in the back to the mounting bracket and
secure in place.
3.
Find the data cable line at the rear of the stove, and plug it
snugly into the back of the control panel.
Placement:
Where you place your stove can significantly affect its performance
and safety.
Sketch out a plan for installing the stove, including dimensions, before
permanent placement. When
determining the location for the stove, wall stud location is critical. You
may need to adjust the location of the stove to avoid encountering a
wall stud. Before placing the pellet stove, connect the vent to allow for
minimum clearances to combustible walls.
Pro Tip: It is recommended that your pellet vent pipe be installed and
serviced by a professional installer.
Installation MUST comply with local, regional, state and national
codes and regulations.
Consult insurance carrier, local building inspector, fire officials, or
authorities having jurisdiction over restrictions, installation
inspection and permits.
WARNING!
Asphyxiation Risk:
DO NOT INSTALL IN A SLEEPING ROOM.
Stove consumes oxygen in the room.
Surge Protector
Protect the electrical
components of your stove by
using a surge protector.
8
Front Door Latch
Control Panel Mounting
Data Wire Connection
comfortbilt.net

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents