Troubleshooting; Listening To Messages - Panasonic KX-TG2322B Operating Instructions Manual

Troubleshooting

Telephone System
Problem
An alarm tone sounds
when you press [C],
[SP-PHONE] or [VOICE
ENHANCER].
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
You cannot program any
functions.
While programming, the
handset starts to ring and
the program stops.
You cannot redial.
You cannot make long
distance calls.
You cannot page the
handset.
34
Cause & Remedy
• You are too far from the base unit. Walk
closer to the base unit and try again.
• Confirm the AC adaptor is plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit.
Register the handset again (p. 23)
• Move the handset and the base unit
away from other electrical appliances
(p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• The ringer volume is turned off. Set to
high, medium, or low (p. 14).
• Programming is not possible while the
handset is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to
messages or the Answering System is
handling a call, you cannot program. Try
again later.
• A call is coming in. To answer the call,
press [C] or [SP-PHONE]. Start again
from the beginning after hanging up.
• If the last number dialed was more than
48 digits long, the number will not be
redialed correctly.
• Please make sure you have long
distance service.
• The handset is too far from the base unit
or is engaged in an outside call. Try
again later.