Using The Base Unit - Panasonic KX-TG2258 Operating Instructions Manual

Using the Base Unit

1
Press [SP-PHONE].
• The SP-PHONE indicator lights.
2
Dial a phone number.
3
When the other party answers, talk
into the MIC (microphone).
4
To hang up, press [SP-PHONE].
• The indicator light goes out.
• To switch to the handset while using the base unit speakerphone:
— If the handset is off the base unit, press [
— If on the base unit, just lift up.
• During a call using the handset, the call can be switched to the base unit by
pressing [SP-PHONE] on the base unit.
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Talk alternately with the other party in a quiet room.
• If you or the other party has hearing difficulty, press VOLUME [ ] to decrease
the speaker volume.
To adjust the speaker
volume (8 levels) while
talking
To increase volume, press
VOLUME [ ].
To decrease volume, press
VOLUME [ ].
• If you try to increase/decrease
volume when it is at the maximum/
minimum level, the base unit will beep
3 times.
To redial the last number
dialed on the base unit
Press [SP-PHONE] then
[REDIAL].
For assistance, please call: 1-800-211-PANA(7262)
Base Unit
] or [
To put a call on hold
Press [HOLD].
• The SP-PHONE indicator flashes.
To return to the call, press
[SP-PHONE].
• The handset user can return to the
call by pressing [
the handset off the base unit.
• If another phone is connected on the
same line, you can also return to the
call by lifting its handset.
• If a call is kept holding for 6 minutes,
an alarm tone will start to sound. After
4 additional minutes on hold, the call
will be disconnected.
• The alarm volume corresponds to the
ringer volume level (p. 17). If the
ringer is OFF, the alarm will sound at
the LOW level.
Making Calls
[REDIAL]
[HOLD]
[SP-PHONE]
and Indicator
MIC
VOLUME [ ], [ ]
].
] or [ ], or lifting
25