Table of Contents
Advertisement
PQQX14031ZA.book 31 ページ ２００４年６月２１日 月曜日 午後３時４４分
Using the Base Unit
Press [SP-PHONE].
1
• The SP-PHONE indicator lights.
Dial a phone number.
2
When the other party answers,
3
speak into the MIC (microphone).
To hang up, press [SP-PHONE].
4
• The indicator light goes out.
• To switch to the handset while using the base unit speakerphone:
— If the handset is off the base unit or charger, press [C] or
then press [SP-PHONE] on the base unit.
— If the handset is on the base unit, just lift up.
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Speak alternately with the other party in a quiet room.
• If you or the other party has difficulty hearing, press VOLUME [
the speaker volume.
To adjust the speaker volume during a conversation
To increase volume, press VOLUME [>].
To decrease volume, press VOLUME [<].
• There are 8 volume levels. If you try to increase/decrease volume when it is at the
maximum/minimum level, the base unit will beep 3 times.
To redial the last number dialed
Press [SP-PHONE], then press [REDIAL].
To put a call on hold
Press [HOLD/CONF] during a conversation.
• The SP-PHONE indicator flashes.
To return to the call, press [SP-PHONE].
• The handset user can also take the call by pressing [C] or [s].
• If another phone is connected on the same line (p. 9), you can also take the call
by lifting its handset.
• If a call is kept on hold for 6 minutes, an alarm tone will start to sound. After
4 additional minutes on hold, the call will be disconnected.
Base Unit
[REDIAL]
MIC
VOLUME [<], [>]
Making Calls
[HOLD/CONF]
[SP-PHONE]
and Indicator
[s]
on the handset,
] to decrease
<
31
Advertisement
Table of Contents
