Remote Operation from a Touch Tone Phone
You can operate the Answering System from any touch tone phone.
A synthesized voice menu will guide you through the Answering System (p. 49).
• To skip the voice menu and operate the unit directly, see page 50.
Summary of remote operation
Call your unit from a touch tone phone.
Enter your remote code (see below) during or
after the greeting message.
• The number of new messages is heard.
After 3 seconds, the voice menu will start
(p. 49).
Follow the menu or enter the direct commands
(p. 50).
To end remote operation, hang up.
Remote Code
The remote code prevents unauthorized people from accessing your unit and
listening to your messages. Choose any 2-digit number (00–99) for your remote
code.
The factory preset remote code is "11". If you do not program your own remote
code, you can use "11".
1
Press [MENU].
2
Scroll to "Initial setting" by pressing [ ]
or [ ], then press Select.
3
Scroll to "Set answering" by pressing [ ] or
[ ], then press Select.
4
Scroll to "Remote code" by pressing [ ] or
[ ], then press Select.
5
Enter a 2-digit remote code (00–99).
6
Press Save, then press [OFF].
To check the remote code, repeat steps 1 to 4.
• The remote code is displayed. When finished, press [OFF].
48
Handset
• The unit will announce the
remaining recording time
after playback, if it is less
than 3 minutes.
• The messages are saved.
Initial setting
Exit
Set answering
Back
Remote code
Back
Remote code
Back
Select
Select
Select
:11
Save