Table of Contents
Advertisement
PLAYBACK
When
connecting the
cables, open
the jack cover.
A
If your TV/VCR
has the SCART
connector, use
the provided
cable adapter.
VCR
To AUDIO,
VIDEO and
RF DC OUT
connectors
NOTES:
● It is recommended to use the AC Power
Adapter/Charger as the power supply instead
of the battery pack.
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power switch to "CAMERA",
then set your TV to the appropriate input
mode.
● If you have a TV or speakers that are not
specially shielded, do not place the speakers
adjacent to the TV as interference will occur
in the camcorder playback picture.
Downloaded from:
Basic Connections
To AUDIO and
VIDEO connectors
Audio and Video
cables (provided)
To AUDIO and
VIDEO IN
connectors
Antenna
RF unit RF-V5E
(optional)
https://www.usersmanualguide.com/
There are three basic types of connections. When making
the connections, refer also to your VCR and TV
instruction manuals.
Connection To A VCR [A]
(Editing, Dubbing and Playback)
NOTE:
Use the provided Audio and Video cables.
CONNECT CAMCORDER TO VCR
1
As shown in the illustration at left, connect the
Audio and Video cables between the AUDIO and
VIDEO connectors on the camcorder and those on
the VCR.
B
SUPPLY POWER
2
Turn on the camcorder, the VCR and the TV.
SELECT MODE
3
Set the VCR to its AUX input mode, and set the TV
to its VIDEO mode.
Connection To A TV With A/V Input
Connectors [B] (Playback ONLY)
NOTE:
Use the provided Audio and Video cables.
CONNECT CAMCORDER TO TV
1
As shown in the illustration at left, connect the
Audio and Video cables between the AUDIO and
VIDEO connectors on the camcorder and those on
the TV.
SELECT MODE
2
Set the TV to its VIDEO or AV mode (as specified in
its instructions).
Connection To A TV With NO A/V Input
Connectors (Playback ONLY)
NOTE:
Use the optional RF-V5E RF unit.
* Refer to the RF-V5E instruction manual for connection
procedure.
27
EN
Advertisement
Table of Contents
