Basic Connections; Tape Dubbing - JVC GR-SXM57 Instructions Manual

Basic Connections

1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration (
If using a VCR . . . go to step 3 .
If not . . . go to step 4 .
3
Connect the VCR output to the TV input,
referring to your VCR ' s instruction manual.
4
Turn on the camcorder, the VCR and the TV.
• Set " VIDEO OUT " of the camcorder according
to the system of the TV or VCR you will be
using ( pg. 9).
5
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
N O TES:
It is recommended to use the AC Adapter as the
●
power supply instead of the battery pack
( pg. 7).
● If your VCR has an S-Video input connector,
connect the camcorder and the VCR using the
provided S-Video cable. This can improve the
dubbed picture quality (GR-SXM607/SXM57/
SXM47/SX202/SX22 only).
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder ' s Power Switch to "
set your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
● If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
● To view the playback picture on a connected
SECAM TV or dub a tape to a SECAM VCR, set
" VIDEO OUT " to " SECAM " (GR-SXM607/SXM57/
SXM47/SX202/SX22 only,
Downloaded from:
pg. 32).
" or "
pg. 9).
https://www.usersmanualguide.com/

Tape Dubbing

1
Following the illustration on pg. 32, connect the
camcorder and the VCR.
• Set " VIDEO OUT " of the camcorder according
to the system of the VCR you will be using
(
2
Set the camcorder ' s Power Switch to "
turn on the VCR ' s power, and insert the
appropriate cassettes in the camcorder and the
VCR.
3
Engage the VCR ' s AUX and Record-Pause
modes.
4
Engage the camcorder ' s Play mode to find a
spot just before the edit-in point. Once it is
reached, press 4 / 6 on the camcorder.
5
Press 4 / 6 on the camcorder and engage the
VCR ' s Record mode.
6
Engage the VCR ' s Record-Pause mode and press
4 / 6 on the camcorder.
7
Repeat steps 4 through 6 for additional editing,
then stop the VCR and camcorder when
finished.
" , then
pg. 9).
33
EN
" ,