Table of Contents
Advertisement
Transmitted beam
effective area
15°
15°
When using the remote control, be sure to
point it at the remote sensor. The above
illustration shows the approximate transmitted
beam effective area for indoor use.
The transmitted beam may not be effective or
may cause incorrect operation outdoors or
when the remote sensor is directly exposed to
sunlight or powerful lighting.
Interval Timer Indicator
1MIN
1/2S
Rec Time Indicator
RM-V704U or RM-V700U
(provided with GR-AX470 only)
Downloaded from:
Remote sensor
(GR-AX470 only)
Viewfinder
INDEX
Index Code
Marking
START/STOP
VISS
INT. TIME
REC TIME
https://www.usersmanualguide.com/
FEATURE:
Self-Timer, Animation and Time-Lapse
PURPOSE:
The remote control lets you set/release
Interval Timer and Rec Time functions as
well as the Menu screen.
OPERATION:
Self-Timer
1) Set
Instead of performing steps 1 through 3
on pg. 24 ("Self-Timer"), press INT.
TIME on the remote control. Each time
INT. TIME is pressed, the Interval Timer
indicator appears, changing in the
following order: 15S, 30S, 1MIN, 5MIN
and No indication (off).
2) Release
Instead of setting "INTERVAL TIMER" to
"OFF" in the Menu, press INT. TIME on
the remote control until the Interval
Timer indicator disappears.
Animation
1) Set
Instead of performing steps 1 and 2 on
pg. 25 ("Animation"), press REC TIME
on the remote control. Each time REC
TIME is pressed, the Rec Time indicator
appears, changing in the following
order: 1/4S, 1/2S, 1S and No indication
(off).
2) Release
Instead of using the Menu in step 5 on
pg. 25, press REC TIME on the remote
control until the Rec Time indicator
disappears.
Time-Lapse
1) Set
Instead of performing steps 1 through 3
on pg. 25 ("Time-Lapse"), press INT.
TIME and REC TIME on the remote
control. Each time INT. TIME is
pressed, the Interval Timer indicator
appears, changing in the following
order: 15S, 30S, 1MIN, 5MIN and No
indication (off). Each time REC TIME is
pressed, the Rec Time indicator
appears, changing in the following
order: 1/4S, 1/2S, 1S and No indication
(off).
2) Release
Instead of using the Menu in step 5 on
pg. 25, press INT. TIME and REC TIME
on the remote control until the
indicators disappear.
NOTE:
Also refer to pgs. 24 and 25.
FEATURE:
Index Code Marking
PURPOSE:
To give you automatic access to any
selected point on a recording.
OPERATION:
1) Press VISS once to place the index
code. "INDEX" blinks in the viewfinder
during marking.
If VISS is pressed during Record–Standby
NOTE:
mode, the mark is placed where
RECORDING START/STOP is pressed.
35
EN
Advertisement
Table of Contents
