Table of Contents
Advertisement
10
EN
Tape remaining time indicator
25MIN
Power indicator
POWER
Start/Stop button
Tally lamp
NOTES:
● A cassette holder can't be opened unless a power supply is attached.
● There may be a delay after you slide EJECT until the holder opens. Do not use force.
● The tape's remaining time is displayed in the viewfinder as shown.
● The indicated remaining time is approximate.
● The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary
according to the type of tape used.
● The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been
selected (
pg. 8).
● "TAPE END" appears when the tape reaches its end, and the power goes off automatically if left in this
condition for 5 minutes. "TAPE END" also appears when a cassette whose tape is already at its end is
loaded.
● If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations,
the camcorder's power shuts off automatically. Set the Power switch to "POWER OFF", and then back to
"CAMERA" to turn the camcorder on again.
● If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5
minutes, recording may not start immediately.
● If you're recording on a cassette from the middle, use the RETAKE function (
the last recording so you don't erase any of it.
● The LENS COVER warning blinks for about 10 seconds when the camcorder is turned on, when the cover
is closed.
Downloaded from:
*- - -MIN
(Now calculating)
60MIN
59MIN
3MIN
2MIN (Blinking)
1MIN (Blinking)
0MIN (Blinking)
LENS COVER
switch
https://www.usersmanualguide.com/
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
pg. 4)
● Tape Length setting (
● Grip Adjustment (
LOAD A CASSETTE
1
Slide EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
ENTER RECORD–STANDBY MODE
2
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
"CAMERA".
•The power indicator lights and the camcorder
enters the Record–Standby Mode.
•The scene you're aimed at appears on the
viewfinder screen, with the word "PAUSE"
superimposed upon it.
START SHOOTING
3
Press the RECORDING START/STOP button.
•The tally lamp lights while recording is in progress,
REC
and "
" appears in the viewfinder.
STOP RECORDING
4
Press the RECORDING START/STOP button again to
stop recording.
•The camcorder re-enters the Record-Standby
mode.
Basic Recording
pg. 8)
pg. 9)
pg. 12) to find the end of
Advertisement
Table of Contents
