Table of Contents
Advertisement
No Video
1. Check that the VGA cable is connected properly, and the monitor is on.
2. Check if you follow the guidelines to install the memory module (see DIMM Module
Population in
Chapter
3. Reseat the memory DIMM modules.
Note: If you are a system integrator, VAR or OEM, a POST diagnostics card is recommended.
Memory Errors
1. Make sure that the DIMM modules are properly and fully installed.
2. Confirm that you are using the correct memory. Also, it is recommended that you use
the same memory type and speed for all DIMMs in the system. See
memory details.
3. Check for bad DIMM modules or slots by swapping modules between slots and noting
the results.
4. Check the power supply voltage 115V/230V switch.
The System Cannot Retain the Setup Configuration
1. Make sure that you are using a high quality power supply. A poor quality power supply
may cause the system to lose the CMOS setup information. Refer to
details on power supplies.
2. The battery on your motherboard may be old. Check to verify that it still supplies
approximately 3VDC. If it does not, replace it with a new one.
3. If the above steps do not fix the setup configuration problem, contact your vendor for
repairs.
2).
36
Chapter 3: Troubleshooting
Section 2.4
for
Section 1
for
Advertisement
Table of Contents
