Jenn-Air RISE JDS1450ML Owner's Manual page 20

3. Unscrew the metal cover and unscrew the blue regulator cap.
Keep the washer in place.
A
A.
Metal cover
B.
Washer
C.
Blue regulator cap
4. Flip the blue regulator cap over and screw it back into the
metal cover.
A
A.
Natural gas position
B.
Propane gas position
5. Screw the metal cover securely back into place. Do not
overtighten.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Remove the burner base.
A
A.
Igniter electrode
B.
Burner cap
C.
Gas tube opening
D.
Burner base
C
A.
Burner cap
B.
Burner base
C.
Choke (for use with large burner, Propane gas only)
20
B
C
D
A
B
Large Burner
4. Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A
B
A
C
5. Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
B
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Fully insert choke into bottom of large burner base. Choke
should snap into place.
NOTE: Use only for speader bases marked "L".
Propane Gas Orifice Spud Chart for Surface Burners.
Placement
LF (ST)
LR
RF
RR
CTR
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door for
proper sizing of spuds for each burner location.
6. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 1 to 7 for the remaining burners.
10. Replace the baking drawer. See the "Remove/Replace
Drawer" section.
B
C
A.
Igniter electrode
B.
Orifice spud
C.
Orifice spud holder
D.
Screws
A
A. Propane groove
Burner Size (mm)
Rating/Type
15,000 BTU 1.08
1,450 BTU 0.35
5,000 BTU 0.64
14,200 BTU 1.08
8,000 BTU 0.84
8,000 BTU 0.84
D
ID Number
108AM
035AM
064AM
108AM
084AM
084AM