Table of Contents
Advertisement
4.9
Usage Menu:
The Usage menu allows for the user to track data about machine usage. See below for
detailed information on each sub menu option.
1. "Coin Audit": The coin audit field shows the accumulation of coin pulses that
were sent to the control over each of the left and right coin inputs. Note that this
is a count of coin pulses, not an accumulated report of vend value.
a. The user can also return the coin audit amounts to the factory default
setting (zero). To reset all coin audit values, press "Enter" when the
"DEFAULT" prompt is shown. Press "Enter" again when the "RESET"
prompt is shown to confirm the action.
2. "Cycle Count": The cycle count field shows the accumulation of wash cycles that
have occurred. Note that this is a count of cycles, not of hours accumulated. The
user can also set the count value to a designated number. For example, if it is
necessary to replace the control on a machine, the new control could be
programmed to show the cycle count value that was recorded by the previously
installed control. The individual digits of the count can be set by using the "Up"
or "Down" buttons to change the number that is flashing. Once the desired digit
of the count is chosen, press the "Enter" button to move to the next digit. Once
the complete count is chosen, the "Enter" button must be held down for 3
seconds to confirm the action.
a. The user can also return the cycle count to the factory default setting
(zero). To reset the cycle count, press "Enter" when the "DEFAULT"
prompt is shown. Press "Enter" again when the "RESET" prompt is shown
to confirm the action.
3. "Motor Hours": The motor hours field shows the accumulated hours of operation
for the motor. In many cases, it will match the cycle hours of the machine.
However, separate fields are provided in the event that a motor is replaced on a
machine. The user can set the motor hours to a designated number. For
example, if it is necessary to replace the control on a machine, the new control
could be programmed to show the motor hours that were recorded by the
previously installed control. The individual digits of the hours count can be set by
using the "Up" or "Down" buttons to change the number that is flashing. Once
the desired digit of the hours is chosen, press the "Enter" button to move to the
next digit. Once the complete hours are chosen, the "Enter" button must be held
down for 3 seconds to confirm the action.
a. The user can also return the motor hours to the factory default setting
(zero). To reset the motor hours, press "Enter" when the "DEFAULT"
prompt is shown. Press "Enter" again when the "RESET" prompt is shown
to confirm the action.
4. "Cycle Hours": The cycle hours field shows the accumulated hours of operation
for the washer. In many cases, it will match the motor hours of the machine.
However, separate fields are provided in the event that a motor is replaced on a
machine. See the Motor Hours description for more information.
8514-298-001 REV A page 33
Advertisement
Table of Contents
