Table of Contents
Advertisement
Quick Links
Installation, Service and User
INSTRUCTIONS
FOR THE
ZERO MODELS:
GF120
SINGLE LID CHEST FREEZER
2-WAY: L.P. Gas & 230V Electric
ZERO APPLIANCES (PTY) LTD
Cat. I
& I
3+ (28–30/37)
3B/P (30)
WARNING: THIS APPLIANCE MUST BE
EARTHED
ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN
CONTACT WITH OR NEAR THE BURNER BOX
Advertisement
Table of Contents
Related Manuals for Zero Appliances GF120
Summary of Contents for Zero Appliances GF120
- Page 1 Installation, Service and User INSTRUCTIONS FOR THE ZERO MODELS: GF120 SINGLE LID CHEST FREEZER 2-WAY: L.P. Gas & 230V Electric ZERO APPLIANCES (PTY) LTD Cat. I & I 3+ (28–30/37) 3B/P (30) WARNING: THIS APPLIANCE MUST BE EARTHED ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN...
-
Page 2: Technical Data
TECHNICAL DATA Zero Appliances Model GF120 Freezer Category: For use on Butane at 2.8-3.0 kPa 3+ (28-30/37) and Propane at 3.7 kPa. For use on Butane and Propane 3 B/P (30) mixtures (LPG) at 3.0 kPa Declared rate: Injector size 0.42mm diameter, marked ‘13’... -
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS: IMPORTANT INFORMATION FOR THE USER Only a registered LP Gas installer may install a gas installation. All registered installers are issued with a card carrying their registration number. Ask to be shown the card before allowing the installation work to commence and make a note of the Installer QCC number. Upon completion of the installation, the installer is required to explain the operational details of the installation together with the safety instructions. -
Page 4: Gas Connection
IMPORTANT: There must be adequate space to reach the controls situated at the back of the appliance. NOTE: Any gas supply cylinder should have at least 250mm clearance if placed behind the appliance. GAS CONNECTION: The appliance inlet is to the 8mm plain straight tube, allowing connection by means of a gas-tight compression fitting to comply with both EC and local regulations. -
Page 5: For Your Safety
FOR YOUR SAFETY If you smell gas: Turn off gas supply at bottle. Extinguish all naked flames Do not operate any electrical appliances. Ventilate the area. Do not smoke while checking for leaks. Do not check for leaks with an open flame. If the odour persists, contact your dealer or gas supplier immediately. -
Page 6: Troubleshooting
Make sure that the electrical supply to the appliance is turned off. 2. Open the shut-off valve for the gas bottle or gas installation 3. Open flap B. 4. Keep the flame failure device knob (A) pressed in for approximately 5 seconds to allow gas to flow to the burner. - Page 7 3. If it is possible to start the appliance on an alternative energy sources. 4. If the appliance fails to work on gas, check: a) That the gas bottle is not empty. b) That the regulator is not faulty. c) If another appliance is connected to the same supply, check if it works properly.
-
Page 8: Some Useful Hints
13. If the flame is not burning after releasing the fail-safe valve knob according to the instructions, there may be two faults, these being: a) The magnet in the flame failure device (2) is faulty. b) The thermocouple feeler point (12) may not be in the flame properly. To rectify this, loosen the thermocouple nuts (13) and adjust the thermocouple until the point is over the second row of the small holes in the burner and re- tighten the nuts on the thermocouple. -
Page 9: Cleaning Your Freezer
11. You avoid packing products in too tightly – air must be able to circulate freely. 12. For the safety of children keep the key out of children’s reach at all times. 13. It is recommended that a suitably qualified person carry out a yearly service check. -
Page 10: In The Event Of Failure
the guarantee extended on the unit to the customer, that any interference with the filling valve screw will automatically void the guarantee. The absorption unit must not be opened, since it contains corroding chemicals under high pressure. SERVICE NOTES ROUTINE MAINTENANCE It is recommended that a suitably qualified person service this appliance at least once a year. -
Page 11: Important Note
IMPORTANT NOTE If there is a smell of ammonia, it is advised that the user turn off the appliance, clear out all the food and remove the appliance from dwelling areas. GAS BURNER PARTS LIST 1. SANS BRASS HOSE TAIL. 2. - Page 12 Guarantee Registration For Guarantee registration please visit: https://zeroappliances.co.za/guarantee-form/ Complete the online form and click submit. Or scan the above QR code with your smart device which will take you to the form. Complete the online form and click submit. Made in South Africa (Pty) Ltd Author: Rudi Version: 2.1...