1. Manuals
  2. Brands
  3. Zero Appliances Manuals
  4. Freezer
  5. GF250D
  6. Installation, service and user

Zero Appliances GF250D Installation, Service And User

Single lid chest freezer
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Installation, Service and User
INSTRUCTIONS
FOR THE
ZERO MODEL: GF250D
SINGLE LID CHEST FREEZER
2-WAY: L.P. Gas & 230V Electric
ZERO APPLIANCES (PTY) LTD
Cat. I
& I
3+ (28–30/37)
3B/P (30)
WARNING: THIS APPLIANCE MUST BE
EARTHED
ENSURE THAT THE GAS SUPPLY HOSE IS
NOT IN CONTACT WITH OR NEAR THE
BURNER AREA

Advertisement

Table of Contents
loading

Related Manuals for Zero Appliances GF250D

Summary of Contents for Zero Appliances GF250D

  • Page 1 Installation, Service and User INSTRUCTIONS FOR THE ZERO MODEL: GF250D SINGLE LID CHEST FREEZER 2-WAY: L.P. Gas & 230V Electric ZERO APPLIANCES (PTY) LTD Cat. I & I 3+ (28–30/37) 3B/P (30) WARNING: THIS APPLIANCE MUST BE EARTHED ENSURE THAT THE GAS SUPPLY HOSE IS...

  • Page 2: Technical Data

    TECHNICAL DATA Zero Appliances Model GF250D Double LID Freezer Category: For use on Butane at 2.8-3.0 kPa 3+ (28-30/37) and Propane at 3.7 kPa. For use on Butane and Propane 3 B/P (30) mixtures (LPG) at 3.0 kPa Declared rate: Injector size 0.42mm diameter, marked ‘13’...

  • Page 3: Installation Instructions

    INSTALLATION INSTRUCTIONS: IMPORTANT INFORMATION FOR THE USER Only a registered LP Gas installer may install a gas installation. All registered installers are issued with a card carrying their registration number. Ask to be shown the card before allowing the installation work to commence and make a note of the Installer QCC number. Upon completion of the installation, the installer is required to explain the operational details of the installation together with the safety instructions.
  • Page 4 IMPORTANT: There must be adequate space to reach the controls situated at the back of the appliance. NOTE: Any gas supply cylinder should have at least 250mm clearance if placed behind the appliance. GAS CONNECTION: The appliance inlet is to the 8mm plain straight tube, allowing connection by means of a gas-tight compression fitting to comply with both EC and local regulations.

  • Page 5: For Your Safety

    FOR YOUR SAFETY If you smell gas: Turn off gas supply at bottle. Extinguish all naked flames Do not operate any electrical appliances. Ventilate the area. Do not smoke while checking for leaks. Do not check for leaks with an open flame. If the odour persists, contact your dealer or gas supplier immediately.
  • Page 6 2. Open the shut-off valve for the gas bottle or gas installation 3. Open flap B. 4. Keep the flame failure device knob (A) pressed in for approximately 5 seconds to allow gas to flow to the burner. 5. Strike a match and insert into flap hole (B). While the flame is burning press and hold the flame failure device for a further 10 seconds.
  • Page 7 2. The evaporator is frosted up – see Defrosting page 7. The gas pressure is incorrect – check the pressure regulator at the gas cylinder or at the jet (6) of the burner. (Page 9 – Gas burner parts list). If the jet (6) is blocked, remove the jet, clean with alcohol or other solvent and blow through with compressed air.

  • Page 8: Some Useful Hints

    SOME USEFUL HINTS Make sure that: 1. Defrosting is carried out periodically. 2. The appliance is clean and dry with the lid open when it is not to be used for some time. If the appliance is fitted with a locking device – remove key to prevent accidental locking.

  • Page 9: Cleaning Your Freezer

    CLEANING YOUR FREEZER  Clean the bin of the appliance using ½ a litre of warm water and a tablespoon of bicarbonate of soda.  Soak a soft cloth in the solution, wring it out, and use it to clean out the interior of the freezer compartment and its fittings.

  • Page 10: In The Event Of Failure

    SERVICE NOTES ROUTINE MAINTENANCE It is recommended that a suitably qualified person service this appliance at least once a year. Inspect the gas hose for cracks and chafing marks. Test all connections with a suitable solution, do not use an open flame. Check there is no smell of ammonia or any signs of green/yellow crystal-like deposits on the cooling unit tubes.

  • Page 11: Important Note

    IMPORTANT NOTE If there is a smell of ammonia, it is advised that the user turn off the appliance, clear out all the food and remove the appliance from dwelling areas. GAS BURNER PARTS LIST 1. SANS BRASS HOSE TAIL. 2.
  • Page 12 Guarantee Registration For Guarantee registration please visit: https://zeroappliances.co.za/guarantee-form/ Complete the online form and click submit. Or scan the above QR code with your smart device which will take you to the form. Complete the online form and click submit. WARNING: THIS APPLIANCE MUST BE EARTHED.

Table of Contents