1. Manuals
  2. Brands
  3. Zero Appliances Manuals
  4. Freezer
  5. GF230IP
  6. Installation, service and user instructions manual

Zero Appliances GF230IP Installation, Service And User Instructions Manual

Single lid, 2-way: l.p. gas & 230v electric, cat. i3+ 28–30/37 & i3b/p 30
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Installation, Service and User
INSTRUCTIONS
FOR THE
ZERO MODEL:
GF230IP
SINGLE LID CHEST FREEZER
2-WAY: L.P. Gas & 230V Electric
ZERO APPLIANCES (PTY) LTD
Cat. I
& I
3+ (28–30/37)
3B/P (30)
WARNING: THIS APPLIANCE MUST BE
EARTHED
ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN
CONTACT WITH OR NEAR THE BURNER BOX

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GF230IP and is the answer not in the manual?

Questions and answers

Related Manuals for Zero Appliances GF230IP

Summary of Contents for Zero Appliances GF230IP

  • Page 1 Installation, Service and User INSTRUCTIONS FOR THE ZERO MODEL: GF230IP SINGLE LID CHEST FREEZER 2-WAY: L.P. Gas & 230V Electric ZERO APPLIANCES (PTY) LTD Cat. I & I 3+ (28–30/37) 3B/P (30) WARNING: THIS APPLIANCE MUST BE EARTHED ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN...

  • Page 2: Technical Data

    TECHNICAL DATA Zero Appliances Model GF230IP Freezer Category: For use on Butane at 2.8-3.0 kPa 3+ (28-30/37) and Propane at 3.7 kPa. For use on Butane and Propane 3 B/P (30) mixtures (LPG) at 3.0 kPa Declared rate: Injector size 0.42mm diameter, marked ‘13’ or 0 Gas consumption: 34.2 g/h...
  • Page 3 IMPORTANT INFORMATION FOR THE USER Only a registered LP Gas installer may install a gas installation. All registered installers are issued with a card carrying their registration number. Ask to be shown the card before allowing the installation work to commence and make a note of the Installer QCC number. Upon completion of the installation, the installer is required to explain the operational details of the installation together with the safety instructions.

  • Page 4: Gas Connection

    GAS CONNECTION: The appliance inlet is to the 8mm plain straight tube, allowing connection by means of a gas-tight compression fitting to comply with both EC and local regulations. The freezer is suitable for connection to butane/propane mixtures (LPG) at 2.8-3.0 kPa and to propane at 3.7 kPa. Means must be provided to turn off the gas supply.
  • Page 5 Do not smoke while checking for leaks. Do not check for leaks with an open flame. If the odour persists, contact your dealer or gas supplier immediately. Do not store or use gasoline or other flammable vapour and liquid in the vicinity of this or any other appliance.
  • Page 6 WARNING: ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN CONTACT WITH OR NEAR THE BURNER BOX. Note: Appliance cannot be run off two heat sources at the same time. TO START GAS OPERATION WARNING: ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN CONTACT WITH OR NEAR THE BURNER BOX.
  • Page 7 before being loaded with products. 10. To terminate the gas operation turn off the shut-off valve on the gas bottle or gas installation. USERS NOTE: The gas safety valve knob (A) should never be depressed for periods longer than 15 seconds with the burner unlit as this can cause a potentially dangerous build- up of unburnt gas.

  • Page 8: Some Useful Hints

    8. Too many products are loaded into the freezer at one time – air must be able to circulate freely. 9. The lid is not properly closed or the lid seal is defective. 10. The baffle has not been inserted into the chimney. 11.

  • Page 9: Cleaning Your Freezer

    7. You have switched on the appliance for approximately 12 hours prior to loading it with products. Avoid packing products in too tightly – air must be able to circulate freely 8. You never put bottles or cans of fizzy drinks in the freezer compartment as they may burst when freezing.

  • Page 10: In The Event Of Failure

     Check the formation of frost regularly and when it gets around 5mm thick, defrost the appliance.  To defrost the appliance, turn it off and remove all food items.  Once defrosting is complete, clean the interior thoroughly. IMPORTANT: ...

  • Page 11: Important Note

    If the burner will not stay alight, check position of the thermocouple (6) point, and the functioning of the flame failure device (3). If not cold enough: Check through points listed under Troubleshooting. In the unlikely event of cooling unit failure, contact the national distributor without delay.
  • Page 12 ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN CONTACT WITH OR NEAR THE BURNER BOX. Made in South Africa (Pty) Ltd Author: Rudi Version: 2.1 Revision: 1.2 Revision Date: June 2019...

Table of Contents