Troubleshooting - Zero Appliances GF120 Installation, Service And User

1.
Make sure that the electrical supply to the appliance is turned off.
2. Open the shut-off valve for the gas bottle or gas installation
3. Open flap B.
4. Keep the flame failure device knob (A) pressed in for approximately 5 seconds
to allow gas to flow to the burner.
5. Strike a match and insert into flap hole (B). While the flame is burning press
and hold the flame failure device for a further 10 seconds. The burner will now
burn with a blue flame.
6. If the flame goes out, repeat steps 4, 5 and 6 until the flame stays alight.
The appliance should be left running for a minimum of 12 hours
7.
before being loaded with products.
8. To terminate the gas operation turn off the shut-off valve on the gas bottle or
gas installation.
USERS NOTE:
The gas safety valve knob (A) should never be depressed for periods
longer than 5 seconds with the burner unlit as this can cause a potentially dangerous build-
up of unburnt gas. If the burner does not ignite, allow sufficient time for any unburnt gas to
disperse, and then repeat the ignition steps.

TROUBLESHOOTING

IF THE APPLIANCE FAILS TO WORK:
Check the following points before calling for service:
1. That the instructions for starting the appliance have been followed.
2. The appliance is level.
Author: Rudi Version: 2.2
5
Revision: 1.3 Revision Date: August 2020