Connections - Panasonic Viera TH-50VX100 Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speaker
terminal (R)
2
Note:
Make sure that the AC
cord is locked on both
the left and right sides.
– Cable fixing band
Secure any excess cables with band as required.
Note:
One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
SLOT1
Dual HDMI Terminals (equivalent
of Dual HDMI Terminal Board
(TY-FB10HMD))
(see page 12)
Note: At factory shipment, Terminal boards are installed in SLOT 1, SLOT 2 and SLOT 3.
AC cord connection (see page 13)
– AC cord fixing
1
1
Plug the AC cord into
the display unit.
Plug the AC cord until it
clicks.
2
Fix the AC cord with
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fixing band around them
then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially
in the power cord), firmly bind all cables with the supplied fixing band.
2
SLOT2
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of RCA Component Video
Terminal Board (TY-42TM6Z))
(see page 12)
Speaker
terminal (L)
Close
Push until
the hook
clicks.
Open
2. Pull off.
1. Keep the
knob pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L
P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 10)
1
2
2
Unplug the AC cord
Unplug the AC
cord pressing the
two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug at
the socket outlet first.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 11)
1
9