Installation; Receiver Location; Optional External Equipment Connections; Ac Power Supply Cord - Panasonic CT-32G11 Operating Instructions Manual

Hide thumbs Also See for CT-32G11:
Table of Contents

Advertisement

Installation
Receiver Location
This unit is intended to be used with an optional stand or entertainment center. Consult your dealer for available options.
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting may reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity, do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor-
mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you'll need.
AC Power Supply Cord
Remote Control Battery Installation
Batteries: Use two "AA" batteries.
1. Turn the Transmitter face down. To remove top cover, press down on
marking and slide cover off in the direction indicated.
2.
Install the batteries as shown in the battery compartment. (Polarity (+) or
(-) must be correct.)
3.
Replace the cover and slide in reverse until the lock snaps.
4.
For heavy Remote Control use, replace old batteries with Alkaline
batteries for longer life.
NOTE: Incorrect installation can cause battery leakage and corrosion that
will damage the Remote Control Transmitter.
Observe the Following Precautions:
1.
Batteries must be replaced as a pair.
2.
Do not combine a used battery with a new one.
3.. Do not mix battery types (Example: Zinc Carbon with Alkaline).
4.
Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries.
5.
Battery replacement is necessary when Remote
Control
reacts
sporadically or stops operating the Receiver.
Polarized Plug
z_
M
m
m
\
Press Down Here
and Slide Cover
Back
-5-

Advertisement

Table of Contents
loading

Table of Contents