Installation; Hoisting; Mounting; Electric Power Supply - Uludag G-400 Manual

2. INSTALLATION

All of our machines are throughly tested in the factory and delivered after ensuring all final checks.
Besides that, all of the standard and optional accessories specified on the enclosed documents must
be checked whether they are existing or not.

2.1. Hoisting

Because of the machine is relatively small and light, it could be readily lifted up and transported either
at least by two people who are holding it at sides in a well-balanced way or by a standard handling truck.
Always pay attention to the warning remarks on the package for transport and storing of the machine.
While transporting with trucks or the like vehicles, make sure that the package is completely secured
against discharge.

2.2. Mounting

We recommend that you should mount the machine onto a bench having approximately 800 mm
height and minimum 750x500 length and width. As a machine workplace, choose a place which is well
lighted and having sufficient space to accomplish cutting operations. Machine doesn't need a special
leveling adjustment, the smoothness of the bench surface on which it is mounted will be enough.
In addition, it is also possible for the machine to be fixed by the two holes at the back of the foot with
two M10x100 bolts onto the bench.

2.3. Electric Power Supply

Before connecting the machine to the power supply line (earthed socket), check if the voltage written
on the electric motor name plate is compatible with the line voltage. If the machine is equiped with three-
phase electric motor, ensure that the rotation is in the direction shown by the arrow on front side of
sawbladeguard. If not, replace the phase line at the centre with any of the phase line at sides.
NOTE:
• Electric motor is designed to be used as alternative. If you are not working on the machine, we
recommend to shut it down.
• If you happen to make use of extension cable, make sure that the cross-section of the power supply
wire has sufficient area to provide required current for the motor power consumption. Using
extension cable as short as possible is recommended.
• Unplug the machine from power line before doing any operation on the machine.
• Do not leave the machine alone without monitoring when it is powered on.

2.4. Sawdust-Bag Connection

A sawdust bag -bag could be mounted to the connection place at the rear of machine.
2.5. Profile Support Connection Connection
The work support component belonging to your machine is supplied together with the machine. The
only thing you should do is to assemble the support shaft to the hole at the side of set-square with
bakalite screw. This part is especially used for mass cutting operations.

2.6. Clamp Connection

Your machine's clamp equipment will facilitate your cutting operation on the machine. Before starting
the cutting operation, tighten and secure the work piece in the clamp on the machine, thus, this will
prevent the possibility of work piece to be thrown away.