Adjustments; Cutting Angle Adjustment; Installing And Replacing The Saw Blade; Cutting - Uludag G-400 Manual

3. ADJUSTMENTS

3.1. Cutting Angle Adjustment

Turning table can be rotated to the right- and left-hand side (CW/CCW). It could be semi-
automatically locked at 0° - 15° - 22,5° - 30° - 45° and central position 90°. To rotate the turning table at
these grades, first press and unload the lock-mechanism, then turn it untill the desired angle is reached
by holding the plastic handle on the head body on which also the electric motor is placed, and lock at
this position with the lock-mechanism. Check whether it is fixed at exact position, by slightly rotating the
head body to the right- and left-hand side.

3.2. Installing and Replacing the Saw Blade

NOTE: Accomplish this operation, after ensuring that the machine is unplugged.
• In order to install sawbladeto its place, follow the steps below:
• Loosen the fixing screw (item no.43) and remove the upper table completely. Disassemble the lower
guard group on the head body.
• Turn the head body into 90°-position.
• Remove M8-20 socket-head screw (item no.31) and take the parts with item no.s 29 and 30 out.
• Place sawbladein-between the parts with no.s 28 and 30.
• Place the items 29 and 30 back again in turn and insert and manually tighten the M8-20 socket-head
screw (item no.31). head body
• Assemble the lower guard group on the head body.
• Mount the upper table and make sure that there is not any tool forgotten on the machine.
NOTE: At the end of all these actions, you will get blade mounted on the machine. If you're not
able to manage to install blade, contact the neighbouring dealer or Uludağ Makina via telephone
or fax.

4. CUTTING

4.1. Cutting Operation

• Loosen and undo the head body retention pin, this will cause the machine move freely up and down.
• Adjust the cutting angle for the work.
• Before cutting operation, tighten and secure the work with the clamp.
• There is a start button for electric motor on the grip, electric motor starts running when this button is
at "I" position. Wait for electric motor to build up its speed (it takes 3-4 seconds).
• Keep your hands off the cutting operation region.
• Set the cutting speed. (do not use higher speeds more than necessary)
• After finishing your cutting operation, turn the button on the grip into "O" position and switch the
machine off.
• Do not attempt to stop sawbladewith your hands or by any other means.

4.2. Angular Cutting at Tilted Position

NOTE: For this operation, you must have already purchased tilted type machine.
Our recommendation is that; during angular cutting operation, first of all, shift the upper table to its
uppermost position, in order to provide a high degree of freedom. The head body on which sawbladeand
electric motor are mounted can only be tilted to the left-hand side up to 45° angle maximum (limit
position) and angular cutting at tilted position can only be achieved when the turning table is at 90°
position (the ruler on the turning table is at "O" position). Tilted position can be maintained as described
below:
• Fix the turning table at 90° position.
• Loosen the M12 retaining nut located behind the machine.
• Use the plastic handle (item no.41) to position the head body on which sawbladeand electric motor
are mounted, at the desired angle. After reaching the predefined angle, tighten the M12 retaining
nut again.