Noise Levels; Transport And Hauling Of The Machiıne - Uludag G-400 Manual

• Electric installation and the equipments (earthed power socket) which will supply power to machine
must comply with the relevant standards and valid rules in force by the authorized organizations.
• Do not attempt to use the machine before securing the work in-between clamp jaws.
• Do not inactivate or remove the safety equipments like safeguards, emergency stop etc. on the
machine.
• Wearing saggy, over-size garments, and use of personal adornments are dangerous for the
operator.
• During operation, use protective goggles against spattering chips and sawdust and earplugs for
noise wherever necessary.
• Install the cutting tool onto the machine and take necessary care for installation.
• Do not touch the cutting tool while the machine is running.
• Do not operate your machine in the combustible and flammable environments.
• Keep the machine away from the humid and damp environments.
• Provide necessary lighting for the workplace.
• Unplug your machine from the power source before attempting to perform any maintainance or
repair.
• Shut your machine down after work is over.
• Clean the sawdust on the machine regularly.
• Keep your workplace in order. Any mess in the workplace increases the accident risk.
• Make use of the recommended accessories for the machine.

1.5. Noise Levels

NORMATIVE REFERENCES: Acoustic test on the machine has been carried out under the following
conditions:
RUNNING CONDITIONS OF THE MACHINE DURING TEST:
Types of saw
Diameter of the saw
Saw speed
Cutting angle
The work material
Work dimensions
The bench on which the cutting machine is fixed
Measured average noise level
Noise level measured at operator's place Lpm = 82,1 dB (A)
Environmental correction factor
The value of the correct noise level
1.6. Transport and Hauling of the Machine
• All of our machines are extensively tested in the factory and delivered as perfectly assembled
situation. If there is any damage happened to machine, the transportation company must be
informed at once.
• Besides that, all of the standard and optional accessories specified on the documents must be
checked whether they are existing or not.
• Transport and placement of the machine must be handled with the proper transport means.
• Pay attention to the warning remarks on the package for transport and storing of the machine.
• Maximum quantity of the machine to be stowed as one above the other is 3.
: DRESS
: 400 mm
: 300 rpm
: 0°, 15°, 22.5°, 30°, 45°
: Wood,Pvc, Aluminium
: 30 x 30 mm
: 750 mm x 500 mm x 800 mm (h)
Idle Under load
Lpm = 74,1 dB (A) Lpm = 74,1 dB (A)
Lpm = 91,3 dB (A)
K = O,9 K = O,9
Lpc = 73,2 dB (A) Lpc = 73,2 dB (A)