Setup Of Screensaver Time - Panasonic TH-42PF20 Operating Instructions Manual

Setup of Screensaver Time

After selecting Time Designation, Interval or Standby after SCR Saver, the relevant Time Setup will become available
for selection and the Operating Time may be set. (Time cannot be set when "Mode" is "On" or "Off".)
Notes:
• Pressing " " or " " button once changes the Time 1 minute.
[However, switching occurs every 15 minutes when Periodic Time is selected.]
• Pressing " " or " " button continuously changes the Time by 15 minutes.
• "Screensaver duration" of the "Standby after SCR Saver" can be set from 0:00
to 23:59. When this is set to "0:00", " Standby after SCR Saver" will not be
activated.
Note: Timer function will not work unless "PRESENT TIME" is set.
Screensaver (For preventing image retention)
Press to select Start Time / Finish Time
(when Time Designation is selected).
Press to select Periodic Time / Operating Time
(when Interval is selected).
Press to select Screensaver duration
(when Standby after SCR Saver is selected).
Press to setup.
button: Forward
button: Back
Screensaver
PRESENT TIME 15:00
Start
Function Scrolling bar only
Time Designation
Mode
6:15
Start Time
12:30
Finish Time
Screensaver
PRESENT TIME 15:00
Start
Scrolling bar only
Function
Interval
Mode
12:00
Periodic Time
Operating Time 3:00
Screensaver
PRESENT TIME 15:00
Start
Function Scrolling bar only
Standby after SCR Saver
Mode
Screensaver duration 6:15
35