Panasonic TH-42PF20 Operating Instructions Manual page 25

High definition plasma display
Table of Contents

Advertisement

Notes:
• If the dot clock frequency is 162 MHz or higher, Dot Clock and Clock Phase cannot be made.
• When digital RGB signal input, Dot Clock and Clock Phase cannot be made.
• Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright image
with borders and other objects are clearly shown, and then try auto setup again.
• Depending on the signal, out of alignment may occur after Auto Setup. Carry out ¿ ne tuning for the
position/size as required.
• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,
1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in "XGA Mode" (see page
49) may results in correct Auto Setup.
• Auto Setup does not work well when a signal such as additional information is superimposed out of
valid image period or intervals between synchronizing and image signals are short, or for image signal
with tri-level synchronizing signal added.
• If Auto Setup cannot adjust correctly, select "Normalise" once and press ACTION ( ), then adjust
Pos. /Size manually.
H-Pos
Adjust the horizontal position.
H-Size
Adjust the horizontal size.
Dot Clock (During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
Clock
(During Component, RGB and PC input signal)
Phase
Eliminate the À ickering and distortion.
Over scan Turn image over scan On/Off.
Con¿ gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)
On
Notes:
• When "Off" is set, "H-Size" and "V-Size" cannot be adjusted.
• When the "Display size" is set to "On" in the Options menu, this setting will be invalid. (see page 54)
V-Pos
V-Size
Off
Adjusting POS. /SIZE
Adjust the vertical position.
Adjust the vertical size.
25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Th-42pf20erTh-50pf20erTh-42pf20eTh-50pf20e

Table of Contents