Selecting The Input Signal - Panasonic TH-42PF20 Operating Instructions Manual

Selecting the input signal

Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Outputs the sound as set in "Audio input select" in the Options menu. (see page
58)
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 47)
• In 2 screen display, the same input mode cannot be selected for the main picture and
sub picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture
is kept on the panel for an extended period. The function that darkens the screen
slightly is activated to prevent image retention (see page 64), but this function is not
the perfect solution to image retention.
Press to select the input signal to be played back from the equipment
which has been connected to the Plasma Display.
Input signals will change as follows:
PC VIDEO COMPONENT*
PC: PC input terminal in PC IN.
VIDEO: Video input terminal in AV IN (VIDEO).
COMPONENT*: Component or RGB input terminal in COMPONENT/
RGB IN.
HDMI: HDMI input terminal in AV IN (HDMI).
DVI: DVI input terminal in DVI-D IN.
* "COMPONENT" may be displayed as "RGB" depending on the setting
of "Component/RGB-in select". (see page 47)
When an optional Terminal Board is installed:
PC SLOT INPUT
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Plasma Display is installed,
"Non-Compatible Function Board" is displayed.
When a Terminal Board with dual input terminals is installed:
PC SLOT INPUT A
SLOT INPUT A, SLOT INPUT B: Dual input terminal in Terminal Board.
HDMI
VIDEO COMPONENT
SLOT INPUT B VIDEO
DVI
HDMI DVI
COMPONENT HDMI
+
INPUT MENU -/ VOL / ENTER/
INPUT MENU - /
DVI
+
VOL / ENTER/
15