Table of Contents
Advertisement
Specifying the Paper Length
•
The specified media type setting is updated in the following situations.
Note
•
When using sheets, if you send a print job before loading a sheet, the media type setting is updated to match the
type of paper specified by the print job.
•
When you have selected ManageRemainRoll > On on the Control Panel and a barcode is printed on the roll, the
media type setting is updated to match the type of paper specified by the barcode.
•
To change the media type setting, see "Changing the Type of Paper."
Specifying the Paper Length
Specifying the Paper Length
When changing the length of paper after the paper has been advanced, specify the length as follows.
•
Specify the paper length when you have set ManageRemainRoll to On. (See "Keeping Track of the Amount of Roll
Paper Left.")
Note
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Paper tab (
Note
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Chg. Paper Size, and then press the OK button.
4
Press ▲ or ▼ to select Roll Length, and then press the OK button.
5
Press ▲ or ▼ to select the length of paper loaded in the printer, and then press the OK button.
Specify the roll length as follows.
1.
Press the ◀ or ▶ button to move to the next field for input.
2.
Press the ▲ or ▼ button to enter the value.
3.
Repeat steps 1 and 2 to finish entering the value, and then press the OK button.
Removing the Roll from the Printer
Removing the Roll from the Printer
Remove rolls from the printer as follows.
•
If you need to cut the roll, see "Specifying the Cutting Method for Rolls."
Note
378
P.383
➔
).
•
If the Tab Selection screen is not displayed, press the Menu button.
P.376
➔
P.386
➔
iPF680
User's Guide
Advertisement
Table of Contents
Troubleshooting
