Table of Contents
Advertisement
correction residual
caused by the test
fixture
Step 1: Press the
Fig.4-17. If you do not want to perform correction, press the Main parameter function
key
to exit. In this mode, only the
are valid. (Open circuit: OPEN, short circuit, SHORT, neither: ERROR). Connect the test
fixture to the gold plated short circuit board (short circuit) or disconnect the outside of the fixture
(open circuit).
Step 2: Press the
identification of open circuit, short circuit, open circuit OPEN, short circuit SHORT) with the
interface as shown in Fig.4-18 (the number will be added 1 along with the correction progress,).
If the correction is successful, the word "success" is displayed in the position where "Digital" is
displayed. If it fails, "FAIL" will be displayed as shown in Fig.4-19; press the
again to return to Interface of Measurement Display.
Fig.4-18
Step 1: Turn on the instrument to enter the interface of measurement display, and press the
key to enter the Interface of System Setting.
Step 2: Move the cursor to "Brightness Adjustment" through the up and down direction keys,
and switch the backlight brightness (30%, 50%, 70%, 100%) through the left and right direction
keys.
impedance
key to enter the correction interface. The interface is as shown in
Fig.4-17
key to carry out open or short circuit correction (automatic
key and the Main parameter function key
Fig.4-19
15
key
Advertisement
Table of Contents
