Front Wheel - Yamaha FZ-07 2015 Owner's Manual

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
3
2
1. Front wheel axle pinch bolt
2. Wheel axle
3. Brake caliper bolt
PERIODIC MAINTENANCE AND ADJUSTMENT
2. Lift the front wheel off the ground
EAU24361
according to the procedure in the
previous section "Supporting the
EAU61491
motorcycle".
3. Remove the brake hose holder on
the left side by removing the bolt.
EWA10822
5
1. Brake hose holder
2. Bolt
3. Reflector
4. Brake caliper
5. Brake caliper bolt
4. Remove the reflector and the
1
brake caliper on each side by re-
moving the bolts. NOTICE: Do
not apply the brake after the
brake calipers have been re-
moved, otherwise the brake
pads will be forced shut.
5. Pull the wheel axle out, and then
To install the front wheel
1. Lift the wheel up between the fork
2. Insert the wheel axle from the right
3. Lower the front wheel so that it is
1
2
4. Install the brake calipers and the
3
TIP
4
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holder by in-
6. Tighten the brake caliper bolts and
[ECA11052]
7-38
remove the wheel.
legs.
side.
on the ground, and then put the
sidestand down.
reflectors by installing the bolts.
stalling the bolt.
the brake hose holder bolt to the
specified torques.
7