Handlebar Switches - Yamaha FZ-07 2015 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
3. Turn the key to "ON" and continue
pushing the left set button until the
display switches to the brightness
control mode.
4. Push the right set button to set the
brightness level.
5. Push the left set button to confirm
the selected brightness level and
4
exit the brightness control mode.

Handlebar switches

Left
1
2
3
4
1. Pass switch " "
2. Dimmer switch " / "
3. Turn signal switch " / "
4. Horn switch " "
Right
1. Start/Engine stop switch "
2. Hazard switch " "
4-10
EAU1234H
Pass switch "
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
1
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
the " " side of the switch. See page
2
6-1 for starting instructions prior to
/ / " starting the engine.
EAU12351
"
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU54211
/ / "
", and then push