Subnet Mask/Ip Address - Ebyte EBT3001 User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

EBT3001 User Manual

123456;

Step 4: The progress bar indicates the configuration progress. Do not refresh the web page again after the

configuration is completed (refresh the web page to enter the configuration mode again, you can restart the device or

submit it again to enter the communication mode);

It can also be opened through the Open Web Configuration button of the configuration software.

[Note] If the port number is modified, the port number should be added to the address input field. For example, if you

modify the web page access port to 8080, you need to enter 192.168.3.7:8080 in the address bar to connect to the web

page configuration.

4.1.2 Subnet mask/IP address

The IP address is the identification of the module in the local area network and is unique in the local area network.

Therefore, it cannot be duplicated with other devices on the same local area network. There are two ways to obtain the IP

address of the module, static IP and DHCP.

(1) Static IP: Static IP needs to be set manually by the user. In the process of setting, pay attention to writing IP, subnet

mask and gateway at the same time. Static IP is suitable for scenarios where IP and device statistics are required and

one-to-one correspondence is required.

Advantages: Access to devices that cannot be assigned IP addresses can be searched through the broadcast mode of the

entire network segment, which is convenient for unified management;

Table of Contents