Advertisement
Quick Links
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are
happy with the product before removing protective film. Once the film is removed you cannot return the product
Be sure to read these instructions thoroughly before opening and installing the Polycarbonate Windshield.
1. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Check
over the parts included in the cartons with the parts list shown below:
1 ¾" Loom Clamps
1" Stainless Steels Bolts
Stainless Steel Washers
Slide fasteners
Lock Nuts
Plastic Thumb Nuts
Sliding Vent Panels
52" Rubber Gasket
55" Rubber Gasket
Bent Polycarbonate Braces
Polycarbonate Windshield
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2. Next take the rubber gasket and starting at one end firmly place along entire bottom and top edges of the
lower Windshield Section. You will need to peel back the protective film from the edge to install the
gasket. If you leave the bulk of the protective film on while installing you can keep from scratching the
windshield. Please see photo below:
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Bobcat 3400
Aero-VentPolycarbonate Windshield
BC-3400-WD05 / 50-40046
for a full refund.
20 each
8 each
8 each
14 each
4 each
10 each
2 each
1 each
1 each
1 each
2 Pieces
Advertisement
Related Manuals for FALCON RIDGE BC-3400-WD05
Summary of Contents for FALCON RIDGE BC-3400-WD05
- Page 1 Instructions for Installation and Care of Bobcat 3400 Aero-VentPolycarbonate Windshield BC-3400-WD05 / 50-40046 NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
- Page 2 3. Next Install the Aero-Vent sliders as shown in the diagram on the following page.
- Page 3 4. Next take the bent Polycarbonate brace and install it on the windshield. Please see diagram on the next page. 5. Now you are ready to place the windshield on the Bobcat and attach to the roll cage. NOTE: THE BEND AT THE TOP OF THE WINDSHIELD SHOULD GO BELOW THE TOP TUBE.
- Page 4 on the next page shows the proper placement for the hardware. Install the clamps as shown for the top two slots in the windshield only. Use the 1” bolts for this application. 6. Now Place the two halves onto the frame as shown on the next page. (diagram not Bobcat) 7.
-
Page 5: Warranty
Warranty To The Owner of this Product: Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product.