Wahl TM602 User Manual page 18

TC6XX-TM6XX Series
 Voltage / resistance or temperature generation / arrow editing?
Press the F2 key to display the edit menu.

Using the navigation keys ( and ), choose the Arrows edit mode and confirm (VAL key).

Use the navigation keys to enter the value:

 and  to increase or decrease the value
o
 and  to select the digit to modify (hundreds/tens/unit/decimal place/hundreds).
o
Indicates that the
mode used is the
arrows mode
Digit
during editing
 Voltage / resistance or temperature generation / incremental editing?
Press the F2 key to display the edit menu.

Using the navigation keys ( and ), choose the INCREASES mode and confirm (VAL key).

The values emitted are those defined in the CONFIGURATION/RAMP menu (see the chapter entitled Related functions).
Using the navigation key (), start the automatic increases phase (following the parameters programmed in the

CONFIGURATION/RAMP menu).
Using the navigation key (), you can decrease automatically starting from the max. programmed voltage (or

temperature).
Using the navigation key (), you can increase manually the voltage (or temperature) emitted (following the

parameters programmed in the CONFIGURATION/RAMP menu).
Using the navigation key (), you can decrease manually the voltage (or temperature) emitted starting from the

max. programmed voltage.
 Voltage / resistance or temperature generation / single ramp editing?
Press the F2 key to display the edit menu.

Using the navigation keys ( and ), choose the SINGLE RAMP mode and confirm (VAL key).

The values emitted are those programmed in the CONFIGURATION/RAMP menu (see the chapter entitled Related
functions).
Using the navigation key (), start the automatic increases phase (following the parameters programmed in the

CONFIGURATION/RAMP menu).
Using the navigation key (), you can decrease automatically starting from the max. programmed voltage (or

temperature).
Using the navigation key (), you can increase manually the voltage (or temperature) emitted (following the

parameters programmed in the CONFIGURATION/RAMP menu).
Using the navigation key (), you can decrease manually the voltage emitted starting from the max. programmed

voltage (or temperature).
The Hold key allows you to stop generating or to resume it
You can resume the generation of the ramp in step-by-step mode by pressing the navigation keys ( and ) or in
automatic generation using the navigation keys ( and ).
You can delay the emission by a programmable amount of time (in the CONFIGURATION/RAMP/DELAY menu)
18
selected
PROGRAMMING MODES