Wahl TM602 User Manual page 16

TC6XX-TM6XX Series
Attention, the choice of °C or °F is made in the Setup\Preferences\temp unit menu.
Using the F1 key, define the CSF used by positioning the cursor on it (for TC621, TM602 and TM630 units

only).
Enter the menu by pressing F2.

Using the navigation keys ( and ), choose the CSF (OFF: None, ON: internal or programmed).

Press VAL to confirm.

Press VAL (again) to confirm the desired function and go back to the measurement screen.

The Measurement mode makes it possible to display the Min (bottom left), Average (bottom centre) and Max
values (bottom right) from the last Min/Max Reset command.
Access this command by pressing the F2 key.

Using the navigation keys ( and ), position the cursor in the Min/Max Reset field.

Confirm the latter using the VAL key.

Note:
Following a significant thermal shock, it is advisable to allow the device to stabilize its temperature to use the
internal reference junction (CSF) with the utmost precision (TC621, TM602 and TM630 units).
16
PROGRAMMING MODES