Powering On The Projector - Compaq iPAQ MP4800 User Manual

Powering On the Projector

1. Make sure the power cord and signal cable are securely
connected.
✎
Make sure the projector is perpendicular to the projection screen.
2. Remove the lens cap 1 from the projector by pressing in
on the tabs on either side of the lens cap and pulling it
straight out.
3. Press the main power switch 2 on the side of the projector
and allow the projector to warm up for one to two minutes.
When the projector has warmed up, the Compaq startup
screen displays and the LED on the
green.
Compaq iPAQ Microportable Projector MP4800 User's Guide
Using the Projector
button 3 turns
Standby
2–7