Installation; How To Fit Blackbird; To Remove The Navigation System From The Cradle - Alpine blackbird PMD-B100P Owner's Manual

INSTALLATION

■ How to Fit Blackbird

3
4
5

■ To Remove the Navigation System from the Cradle

8
WARNING
Incorrect installation may cause the navigation system
to fall out of the cradle while driving. Please make sure
all locks and knobs are turned tight.
Do not install the navigation while driving.
1
Find a suitable spot for the navigation system.
Ensure that both the suction cup and windscreen area
are clean and free of dirt and grease before attaching it.
Stick the suction cup mount against the windscreen.
Turn the knob to activate the vacuum to lock the posi-
tion.
2 Turn the knob counter-clockwise to adjust up/down
position. Then turn clockwise to set the position.
3 Turn the knob clockwise to adjust right/left position.
Then turn counter-clockwise to set the position.
DEVICE SHOULD NOT BE INSTALLED SO THAT IT
OBSTRUCTS THE DRIVER'S VIEW.
2
Open the antenna before inserting the navigation
4
system into the cradle. For best reception, position the
antenna 90 degrees to the main unit.
Slide the navigation system into the cradle until you
5
hear a "click".
6 Plug the cigarette lighter charger into the cigarette
lighter socket.
CAUTION
Remove the navigation system when you are away
from the vehicle to prevent theft.
1
Press and hold the eject button on the cradle.
2 Take hold of the navigation system behind the antenna
and remove by sliding up and out of the cradle.